Maxx-world CS 116, Instruction Manual

Page: 20 / 52

20
2. Screw the support bars onto the bottom of the device en-
closure. Use the fastening material supplied to do this! The
smaller support bar should be at the front (below the tension
knob).
3. Turn the pedals tight on the pedal mounts using the spanner
which is supplied. Make sure that the markings L (left) and R
(right) on the pedals and mounts match.
The right pedal (right-hand thread) is tightened in the
clockwise direction.
The left pedal (left-hand thread) is tightened in the
anticlockwise direction.
4. Make sure that all parts are fi rmly attached to the device before you use the device!
Adjusting the Pedal Straps
You have the option of adjusting the strap size on the pedal. To do
this, unscrew the cross-head screws on the pedals and adjust the
straps to the size you want. Then tighten the screws again.
Inserting the Battery into the Training Computer
1. Carefully remove the computer from the device enclosure.
2. Place the enclosed battery into the battery compartment. Pay
attention to the correct polarity (+ / –).
3. Insert the computer back into the device enclosure.
If the training computer stops working, the battery needs to be
replaced.