Maxwell MW-2112 BK, Manual Instruction

Page: 11 / 32

11
ENGLISH
•
The unit is not intended for usage
by physically or mentally disabled
persons (including children) or
by persons lacking experience or
knowledge if they are not under
supervision of a person who is
responsible for their safety or if they
are not instructed by this person on
the usage of the unit.
•
For children safety reasons do not
leave polyethylene bags used as a
packaging unattended.
•
At
tention!
Do not allow children
to play with polyethylene bags or
packaging film.
Danger of suf-
focation!
•
Do not use the hair clipper if the
power cord or the plug is damaged
or if the unit works improperly.
•
Do not repair the unit by your-
self. Do not disassemble the unit
by yourself, if any malfunction is
detected or after it was dropped,
unplug the unit and apply to any
authorized service center from the
contact address list given in the
warranty book and on the website
www.maxwell-products.ru.
•
To avoid damages, transport the
unit in the original package only.
•
Keep the unit out of reach of chil-
dren.
THE UNIT IS INTENDED FOR
HOUSEHOLD USAGE ONLY
USING THE HAIR CLIPPER
–
After unit transportation or storage
at low temperature keep it for at
least three hours at room tempera-
ture before switching on.
–
Remove all stickers and packag-
ing elements that can prevent unit
operation.
Blades
–
If the blades have been removed
for cleaning or replacement, install
them back to their places and tight-
en the fastening screws. The unit’s
design makes it unnecessary to
level the blades after installing them.
Lubricating oil
–
To maintain the hair clipper in a
good condition, you should lubri-
cate the blades regularly. Do not
use vegetable oil or oil that includes
solvents. Solvents are subjected
to evaporation, and the remaining
thick oil can slow down the upper
blade (4) moving speed.
–
For lubricating the blades use only
the oil (10), supplied with the unit.
Taper lever (2)
–
The taper lever (2), that moves
lower blade (3), is located under
the thumb (if you are right-hand-
ed). When cutting hair you can
move the blade, pressing the
lever (2), thus adjusting the cut-
ting length without usage of the
attachment combs. In upper lever
position, haircut will be the short-
est one. In down lever position the
cutting length is approximately the
same as with 3 mm attachment
comb (6). By changing the posi-
tion of the lever while cutting hair,
you can select the necessary cut-
ting length.
IM_MW-2112_100 x140_2 var.indd 11 19.08.2016 9:19:26