Maxwell MW-2112 BK, Manual Instruction

Page: 12 / 32

12
ENGLISH
–
If hair is jammed in the blades (3, 4)
while cutting, move the lever (2)
from the upper position to the down
position several times, this will help
to release the jammed hair without
removing the blades.
–
When the hair clipper is switched
on, move the lever several times
from the upper position to the lower
position, this way you can remove
the cut-off hair from the blades.
–
If the unit pulls hair while cutting, it
means that the blades (3, 4) became
blunt, replace them with new ones.
Instructions on hair cutting
•
Hair should be clean and dry while
cutting.
•
Insert the power plug into the mains
socket.
•
Before cutting hair, switch the unit
on by moving the power switch (1)
to the position «I» and make sure
that the hair clipper operates nor-
mally and the blades move smooth-
ly. If there is excess oil on the
blades, remove it with a dry cloth.
•
Constantly check the power cord,
avoid its multiple twisting, regularly
switch the unit off and straighten the
power cord.
•
Seat the person so that his/her
head is approximately at your eye
level, cover the person’s shoulders
with a towel and set hair with the
comb.
Attention:
–
Always cut off a little amount of hair
at a time – you can always return to
the trimmed area for additional cut-
ting if needed.
–
The best haircutting results are
reached on dry hair, not wet.
–
Set the hair with the comb to reveal
uneven locks.
–
It is better to leave longer hair after
cutting for the first time.
–
After learning your clipper better,
you will be able to arrange your hair
in any style you need.
Attachment combs
The length of hair depends on the
attachment comb:
•
Attachment comb (6): hair length
3 mm
•
Attachment comb (7): hair length
6 mm
•
Attachment comb (8): hair length
9 mm
•
Attachment comb (9): hair length
12 mm
Set the attachment upper part on the
stationary blade and press it until the
lock clicking. To remove the attachment
comb press the clamp and remove the
attachment.
Step one
Set the 3 mm attachment comb (6) or
6 mm attachment comb (7). Switch
the unit on using the power switch (1),
setting it to position «I». Hold the unit
with the blades pointed upwards. Start
haircutting from the beginning of the
hair growth. Slowly move the clipper
upwards. This way cut the head back
area at neck bottom and near the ears
(pic. 1, 2, 3)
Step two
Switch the unit off using the power
switch (1) by setting it to the “O” posi-
IM_MW-2112_100 x140_2 var.indd 12 19.08.2016 9:19:26