Maxwell MW-2030 BN, Instruction Manual

Page: 9 / 24

9
ENGLISH
«fingers» volumize your hairstyle. Direct the air
flow at the hair roots.
Overheating protection
Overheating protection switches the hairdryer
off if the outgoing air is too hot. If the hair-
dryer switches off during operation, set the
switch (1) to the «0» position, unplug the hair-
dryer and make sure that the inlets and outlets
are unblocked. Let the hairdryer cool down for
5–10 minutes and switch it on again. Do not
block the air inlets during unit operation and
avoid getting of hair into its air inlet.
CLEANING AND CARE
The hairdryer is intended for household usage
only.
1.
Set the switch (1) to the «0» position and
unplug the hairdryer.
2.
Wipe the unit body with a damp cloth and
then wipe it dry.
3.
Turn the grid (5) counterclockwise and
remove it from the unit body. Clean the grid
(5) with a brush and install the grid (5) back
to its place.
4.
Never immerse the unit into water or other
liquids.
5.
Do not use abrasives and solvents to clean
the unit body.
STORAGE
–
Unplug the hairdryer if you are not using it.
– Let the unit cool down after using it and keep
it in a dry cool place out of reach of children.
–
Never wind the power cord around the hair-
dryer, as this can damage the cord. Handle
the power cord with care, do not pull, twist
or stretch it, especially near the power plug
or at the junction point. Straighten the cord
periodically if it gets twisted during ope-
ration.
–
For easy storage there is a hanging loop (7),
you can hang the unit on this loop provided
that no water gets on the unit in this position.
DELIVERY SET
Hairdryer – 1 pc.
Nozzle – 1 pc.
Diffuser – 1 pc.
Instruction manual – 1 pc.
TECHNICAL SPECIFICATIONS
Power supply: 220–240 V ~ 50 Hz
Power consumption: 1800-2000 W
The manufacturer preserves the right to change
the specifications of the unit without a prelimi-
nary notification.
Unit operating life is 3 years
Guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appli-
ance was purchased. The bill of sale or receipt
must be produced when making any claim under
the terms of this guarantee.
This product conforms to the EMC-
Requirements as laid down by the Council
Directive 2004/108/ЕС and to the Low
Voltage Regulation (2006/95/ЕС)
MW-2030.indd 9 24.03.2014 16:29:44