Attaching Antenna Mount Plate & LNB Park Plate:
1.
Remove antenna unit from wooden transit packaging
2.
Remove mounting plate from Antenna Unit by removing 6 x M6 nuts using 10mm spanner
3.
Clean roof, Mounting Plate and LNB Park Plate in accordance with adhesive manufacturer’s guidelines
4.
Mark a centre line for the antenna making sure dish will not overhang vehicle
5.
Align notches on plate with centre line
6.
Mark the position of 6 screw fixing holes and centre hole
7.
Mark position of LNB Park Plate
Page 6
10.
Apply rings of adhesive* (see page 4) to
surface of Antenna Mounting Plate and LNB
Park Plate and firmly place them into position.
Important Note:
Adhesive MUST be used to give a water tight
seal between mounting plate and installation
surface.
8.
Drill 6 x 2.5mm pilot holes into the roof
9.
Using a 32mm holesaw drill the centre hole
through the roof
230mm 65cm (B2590/65)
350mm 85cm (B2590/85)
Direction of travel
Central Line
Antenna Mount Plate
LNB Park
Plate
Summary of Contents for Crank Up B2590/65
Page 20: ......
