Maxview B2590/65, Installation, Operation And Instruction Manual

Page: 9 / 28

9
Attaching Antenna Mount Plate & LNB Park Plate
1. Remove antenna unit from wooden transit packaging.
2. Remove mounting plate from Antenna Unit by removing 6 x M6 nuts using 10mm spanner.
3. Clean roof, Mounting Plate and LNB Park Plate in accordance with adhesive
manufacturer’s guidelines.
4. Mark a centre line for the antenna making sure dish will not overhang vehicle.
5. Align notches on plate with centre line.
6. Mark the position of 6 screw fixing holes and centre hole.
7. Mark position of LNB Park Plate.
8. Drill 6 x 2.5mm pilot holes into the roof
9. Using a 32mm holesaw drill the centre hole through the roof.
10. Apply rings of adhesive* to surface of Antenna Mounting Plate and LNB Park Plate and
firmly place them into position.
LNB Park Plate
Direction of travel
Centre Line
Antenna Mount Plate
Important Note:
Adhesive MUST be used to give a
water tight seal between mounting
plate and installation surface