Maxview B2590/65, Installation, Operation And Instruction Manual

Page: 10 / 28

10
11. Place a small amount of adhesive into each pilot hole before screwing plate to roof.
12. Wipe off excess adhesive with a cloth.
Note
Follow manufacturer’s instructions when applying adhesive. Do not travel until adhesive
has cured noting that curing times vary with weather conditions.
Take care when working at heights. Always follow ladder manufacturer’s safety advice.
Use creeper boards where necessary to ensure roof construction can support your weight.
Power tools should be used in accordance with manufacturer’s instructions.
Attach Antenna Unit to Mounting Plate
Carefully lower the antenna unit onto the Mounting Plate and re-attach the M6 Nuts and Washers
that were previously removed.
Caution
Replace Nylon locking nuts if they have been removed more than twice. The locking action of the
Nylon becomes less effective if repeatedly assembled and disassembled.
Note:
Do not remove transit tape x 2
7 x No. 10 screws (large)