MaxTronic SS-6601E, User Manual

Page: 30 / 32

20
SS-6601E & SS-6601R SAS Disk Array Systems
3
M
a
in
te
n
a
n
c
e
–
R
e
p
la
c
in
g
a
P
o
w
e
r
S
u
p
p
ly
Replacing a Power Supply
The disk array system is equipped with a Power Supply Fail Indicator LED at the front of
the unit that turns red when one of the power supplies fails. The message “Power x fail-
ure” also appears on the LCD panel, where x refers to power supply 1, or 2, and an
audible alert sounds.
Power supplies are hot swappable, which means that they can be inserted and removed
while the disk array is powered on and operating. Follow these instructions to replace a
failed power supply.
1
Identify the power supply that has failed.
2 Remove the power cable from the power supply connector at the rear of the unit.
3
Loosen the power supply retaining screw.
4
Remove the faulty power supply by pulling the power supply handle
A
and
pressing the release catch B at the same time.
5
Insert a new power supply.
6
Tighten the power supply retaining screw.
7 Reconnect the power cable.
Note
Turn off the audible alert by pressing the Up and Down function but-
tons on the front panel twice simultaneously.
LAN
COM
CTRL ready
EXP Access
EXP Link
LAN
COM
CTRL ready
EXP Access
EXP Link
Controller B
Controller A
CH 2
CH 1
CH 2
CH 1
Fan2
Fan3
Fan1
UPS
P/S
Chassis
ID
Power Supply
retaining screw
LAN
COM
CTRL ready
EXP Access
EXP Link
LAN
COM
CTRL ready
EXP Access
EXP Link
Controller B
Controller A
CH 2
CH 1
CH 2
CH 1
Fan2
Fan3
Fan1
UPS
P/S
Chassis
ID
Release
catch
B
A
LAN
COM
CTRL ready
EXP Access
EXP Link
LAN
COM
CTRL ready
EXP Access
EXP Link
Controller B
Controller A
CH 2
CH 1
CH 2
CH 1
Fan2
Fan3
Fan1
UPS
P/S
Chassis
ID