MaxTronic JanusRAID II SA-6651E, Hardware User Manual

Page: 26 / 30

16
SA-6651E Serial ATA II Disk Array Systems
3
Ma
inten
ance
–
Rep
lacing a Powe
r Supp
ly
Replacing a Power Supply
The disk array system is equipped with a Power Supply Fail Indicator LED at the front of
the unit that turns red when one of the power supplies fails. The message “Power x fail-
ure” also appears on the LCD panel, where x refers to power supply 1, or 2, and an
audible alert sounds.
Power supplies are hot swappable, which means that they can be inserted and removed
while the disk array is powered on and operating. Follow these instructions to replace a
failed power supply.
1 Identify the power supply that has failed.
2 Remove the power cable from the power supply connector at the rear of the unit.
3 Loosen the power supply retaining screw.
4 Remove the faulty power supply by pulling the power supply handle A and
pressing the release catch B at the same time.
5 Insert a new power supply.
6 Tighten the power supply retaining screw.
7 Reconnect the power cable.
Note
Turn off the audible alert by pressing the Up and Down function but-
tons on the front panel twice simultaneously.
COM
UPS
Power Supply
retaining screw
COM
UPS
Release
catch
B
A
COM
UPS