MaxPro MPAG650/100, User Manual

Page: 10 / 110

10
Caution!
Before you start working with the two-handed angle grinder, check whether the voltage stated on
the specification plate of the angle grinder corresponds to the available grid voltage.
After switching off, the appliance continued to run on for a few seconds. Wait until the abrading disc has
come to a stop before laying the appliance down.
Insert the mains plug in a properly installed socket.
1. Set the On/Off switch to position (1) to switch the appliance on.
2. Set the On/Off switch to position (0) to switch the appliance off.
Adjusting the guard
Turn the guard so that the exposed part of the disc is located as far as possible from your hand on the
handle.
Note:
If applicable, you must stop working in order to adjust the position of the guard
Grinding and fine grinding
"Grinding" refers to working on a surface with a very coarse tool (e. g. a file or sandpaper). When grinding, a
large amount of material is removed, this is therefore always the first work step. Afterwards, the surface can
be worked on with a finer tool.
1. Mount a corresponding disc.
2.Turn on the device and allow it to run without applying a load.
3.Turn the device so that that the disc is at an approximately 150 angle to the work
ƉŝĞĐĞ͘zŽƵǁŝůůĂĐŚŝĞǀĞďĞƐƚ
results in this way and protect the device from being overloaded.
4.Work on the surface using uniform circular movements.
Buffing
1.Remove the guard
2.Mount a buffing disc.
3.Turn on the device and allow it to run without applying a load.
4.Buff the surface using uniform circular movements.
Cut-off grinding
7
8
9
Angle Grinder MPAG650/100 User Manual
GB