Installation & Operation
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the
fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
1.
Remove the new LED fixture from packaging and inspect for any damage. Handle new LED fixture with care.
2.
Connect the LED high bay wiring to line wire, black to black, white to white and green to green. Use only UL listed wiring.
3.
Clean all residues/fingerprints from the new LED high bay and lens. Double check all
hanging hardware before moving onto the next installation.
A: V-hook Mounting Installation (V-hooks included)*
1.
Ensure that both 40” knotted chains have a small hook on both ends. (
Figure A-2
)
2.
Install both v-hooks onto each side of the fixture body. (
Figure A-3
)
3.
Connect the v-hooks to the chains with the hooks on each chain. (
Figure A-4
)
B: Cable Mounting Installation (cables available separately)*
Materials Required (
Figure B-1
):
One (1) LED fixture
BLHE Series
Two (2) Metal cables (not included)
1.
As shown in
Figure B-2
one end of the sling is buckled and fixed and the
other is the regulator.
2.
Press down on the end of the regulator, then one end of the sling can be pulled
out. Adjust to required height. (
Figure B-3
)
3.
Make sure the fastener passes through the hole in back of fixture completely,
then hang the luminaire. (
Figure B-4 & B-5
)
4.
Once all four fasteners are passed through installation is complete.
(
Figure B-6
)
© Copyright 2020. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: [email protected]
Page: 2
REV: 12/02/20
Operating Instructions BLHE3 Series
MaxLite BayMax Linear High Bay Eco Series
®
Standard Wiring Diagram
CAUTION:
Turn off electrical power at
fuse or circuit breaker box before wiring
fixture to the power supply.
All units must be individually connected
to the AC supply.
BLACK (LINE)
WHITE (NEUTRAL)
GREEN (GROUND)
LED Driver
PURPLE GRAY
BLUE RED
DIM (+) DIM (-)
(-V)
(+V)
(DIMMING WIRES TO 0-10V
IEC COMPLIANT CONTROL.)
YELLOW
BROWN
AUX+
AUX-
