Motion Sensor Model Installation Instructions
© Copyright 2020. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: [email protected]
Page: 4
REV: 12/02/20
1.
Using a screwdriver, open the cover of the junction box.
2.
The motion sensor is already wired to the driver. Carefully, feed the motion sensor wires into the fixture until the sensor’s
female thread makes contact with the male thread sticking out of the knockout.
3.
Screw the two threads together to secure the motion sensor.
4.
Remove the desired knockout for the power supply conduit. Feed the conduit through the knockout.
5.
Connect the supply’s black hot wire to the leading black wire, the supply’s white common wire to the leading white wire.
Connect the green wire to ground.
Operating Instructions BLHE3 Series
MaxLite BayMax Linear High Bay Eco Series
®
Emergency Battery Unit Wiring Diagram
1.
Use a screwdriver to open the junction box on the rear of the fixture. Remove the desired knockout.
2.
Feed the conduit through the knockout. Connect the black hot wire to the leading black wire, the supply's white common neutral
wire to the driver's white wire. Connect the green wire to ground.
3.
Place the cover of the junction box back into place and secure using a screwdriver.
RE
D
BL
UE
BL
UE
O
UT
PU
T
TEST BUTTON
EMERGENCY
DRIVER
EMERGENCY
BATTERY
DRIVER 2
DRIVER 2
LI
NE
, B
L
NE
UT
RA
L,
W
H
RE
D
RE
D
O
UT
BLACK/WHITE
LI
NE
, B
LA
CK
RED OUTPUT
BLUE OUT
RE
D
O
UT
PU
T
BL
UE
O
UT
WHITE INPUT
BLACK INPUT
BBU HARNESS
HARNESS
WHITE
BLACK
GROUND
