Enrollment
1. Press the enroll button of RF repeater, one beep is heard and the
LED lights up in red to enter into enrolling status ( Press again the
Enroll Button within 30 seconds to exit enrolling state.)
2. Enroll the alarm control panel by triggering its enroll button or
tamper switch.
Enroll the accessories by triggering, for example, pressing any
button of remote control, depart the transmitter and magnet of
door sensor etc.
Button Operation
Note: Accessories which already connected with
control panel also need to pair with repeater.
2
3
Repeater beeps once, the LED light flashes
once, the enrollment is successful.
If repeater beeps twice and the LED light
flashes once,the accessories have been
enrolled before.
If three beeps are heard and LED light
flashes once, the storage is full.
1
Notice:
1. The back-up battery only for emergency use, AC power should
be the main supply.
2. Do hot hit or drop the repeater in case of damage component
inside.
3. The strobe siren should be tested regularly, so that all fault
can be fixed in time.
4. Do not install the device lower than 1.2 m .
5. Each accessory and the control panel can not be too close,
otherwise it will effect the transmitting.
Installation
Fix the the plug on detector properly by rotating.
And then power it on.
Delete Enrolled Wireless Accessories
Press and hold the enroll button for 5 seconds
until one beep is heard. All enrolled wireless
accessories will be deleted.
Function
Opcration
Turn On Repeater
Status
Turn Off Repeater
Turn On/Off LED
Indicator
Enters into Enroll
State
Delete Enrolled
Wireless
Accessories
Press Enroll Button
for 3 seconds
The repeater beeps once,
the LED indicator light up
in green color.
The repeater beeps once,
the LED indicator blacks out.
The repeater beeps once,
the LED indicator blacks
out or light up.
The repeater beeps once,
LED indicator light up in red.
The repeater beeps once.
Press Enroll Button
once
Press Enroll Button
for 5 seconds
Press Enroll Button
for 5 times
Press Enroll Button
for 10 times
1
Turn On/Off
Siren Sound
Press Enroll Button
3 times
The repeater beeps once,
the LED indicator blacks
out or light up.
