2
5
7
1
3
3
6
8
9
4
13
12
model no. 058-9340-0 | contact us 1-888-670-6682
• It is recommended that a filter-regulator-lubricator be used and be located
as close to the tool as possible.
• If a filter-regulator-lubricator is not installed, place up to 6 drops of
pneumatic tool oil into the air inlet plug before each use.
• If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty
filter will reduce the air pressure to the tool, which will cause a reduction in
power, efficiency, and general performance.
• For optimal performance, install a quick connector to the tool and a quick
coupler on the hose, if applicable.
• Verify that all connections in the air supply system are sealed in order to
prevent air leakage.
WARNING!
Potential hazard that could result in serious injury or loss
of life.
• Keep hands and other parts of the body away from the tool’s
discharge and working areas when connecting the tool to the
air supply. Failure to comply could lead to serious injury or
loss of life.
WARNING!
Potential hazard that could result in serious injury or loss
of life.
• Do not use the tool if it is not in proper working order.
• Do not use oxygen or any other combustible or bottled gas to
power this tool.
• Do not use this tool in the presence of any flammable liquids or
gases.
• Keep hands and other parts of the body away from the firing
head during use.
• Do not point the tool towards the operator or other people.
• Do not attempt to clear a jammed nail when the air hose is
connected.
• Do not drive a nail on top of an existing nail. Failure to comply
could lead to serious injury or loss of life.
Air system
• Always use clean, dry, regulated, compressed air at 4.8 to 7.5 bar
(70 to 110 PSI).
• Do not exceed the maximum or minimum pressures. Operating the
tool at inappropriate pressure (too low or too high) will cause
excessive noise or rapid wear.
No.
No.
6
7
8
9
Read this Instruction Manual carefully before using the tool.
• Read and follow all the safety instructions at the beginning of this manual.
Inspect the Air-powered Brad Nailer prior to each use in order to:
– Ensure that the proper power source is being used.
– Verify that the tool is in proper working order.
– Verify that the air pressure level(s) are properly set on the air
compressor.
1
2
3
4
5
Description
Description
MAXIMUM
®
Air-powered
Brand Nailer
Quick connector
Quick coupler
Air hose
Lubricator
Regulator 0
–
123 PSI
(0
–
8.5bar)
Filter
Cut-off valve
Air compressor
TM
