26
MAX Super 1300/2300 Arms V1
9
entrapment protection locations
At least ONE entrapment protection device MUST be installed or the operator will NOT function. Typically it is the CLOSING
direction photocell.
Entrapment sensors MUST be installed in BOTH opening and closing direction of gate movement where
entrapment or pinch point exist.
Wireless
Module
Beam Height:
21” Normal
27.5” Max.
Beam: 5” or LESS from CLOSED gate.
CLOSING direction Photocell
Entrapment
Area
Entrapment Area
Gate Open
Gate Open
Entrapment Protection
10K Sensing Edge,
Install along entire
edge of gate.
The hinge area may need protection
against entrapment. MAX 10K mini
sensing edge works well in this area.
(OPEN/CLOSE direction input)
Gate Closed
Normally CLOSED (N.C.)
OPENING direction
Photocell
IMPORTANT:
Sensing edges MUST be
Monitored 10K Normally Closed Type.
Closed Gate
Hinge Area
End of Gate Options
IMPORTANT:
Photocells MUST
be in alignment or fault will occur.
OPENING/CLOSING
Two Sided 10K Sensing Edge
CLOSING ONLY
One Sided
10K Sensing Edge
Closed Gate
Closed Gate
OPENING/CLOSING or
Closing ONLY 10K (N.C.)
Sensing Edge
WIRELESS NOTE: Refer to the instruction sheet that
comes with the wireless module for wiring and
mounting instructions when using wireless option.
Top View
Side View
See “GATE SAFETY and REQUIREMENTS” in
front of this manual for entrapment protection
requirements, locations etc, pages 4-11.
Max 10K Mini
Sensing Edge
(N.C.)
OPENING direction Photocell
CLOSING direction photocell
If distance is less than
16 inches, entrapment
protection is REQUIRED
in this area.
The following is a list of recommended safety devices for the MAX Arm Operators (sold separately).
Omron E3K-R10K4-10R Photocell (Reflector)
EMX IRB-MON Photocell (Thru-Beam)
EMX IRB-RET Photocell (Reflector)
EMX Wireless Edge Link WEL-200T / WEL-200R
Enforcer E931-S50RRGQ Photocell (Reflector)
Enforcer E960-G90GQ Twin Beam (Thru-Beam)
Miller Edge Prime Guard Photocell (Thru-Beam)
Miller Edge GEM-104 10K to NC Converter
Miller Edge R-Band Wireless Edge Unit
P/N: RB-G-RX10 & RB-TX10
Transmitter Solutions IGAZER50LR-UL Photocell (Reflector)
Transmitter Solutions IGAZESR66HD Photocell (Thru-Beam)
Transmitter Solutions Wireless Edge Sensor Model: RCOO900
P/N: IGAZEREKIT-UL
ASO Edge MAX Mini Edge Contact Edge Sensor
ASO Edge Thin Edge MAX Edge 1 Contact Edge Sensor
list of Sensors - UL325 2018
Summary of Contents for MAX SUPER ARM 2300
Page 2: ......
