RM350
INSTALLATION AND COMMISSIONING
RM350 GAS CONTROLLERS
MAY 16
4 of 18
Installing the Equipment
Installation and Location
The gas controller
MUST
be installed indoors.
Never operate, store or transport the gas controller where there may be:
Rainfall or other falling water.
Excessive dust.
Corrosive vapours or substances.
Lying water.
A risk of the temperature falling below 0ºc (32ºF).
Where the ground is slopping or uneven ground.
Do not cover the gas controller during operation, or obstruct the flow of any cooling air in any way.
General Information
Photographs shown within this manual section are for illustration purposes only. All hardware and
fabrications are subject to change without prior notification.
Before operating or carrying out maintenance on the equipment, operators and maintenance
personnel MUST be familiar with the layout, connections and operation of the equipment.
Safety valves MUST NOT be tampered with as they are factory set and could cause irreparable
damage to equipment and cause serious injury.
All equipment or pipe work installed MUST be rated correctly for the operation pressure of the gas
controller.
Even if you are only using the controller with one molding machine, both interface plugs must
still be used, and the E-stop connections must both be either connected or linked out. The
controller will not run unless E-Stop signals are present in both interfaces.
