INSPECTION
Carefully unpack and inspect your vacuum
for shipping damage. Each unit is oper-
ated and thoroughly inspected before
shipping, and any damage is the respon-
sibility of the carrier who should be noti-
fied immediately.
ELECTRICAL
This vacuum operates on a standard 15
amp, 115 volt AC circuit.' Voltages below
105 volts or above
125
volts could cause
serious damage to motors.
'230
volt
50
model available.
Make sure you are using
the correct voltage as specified on name-
plate before connecting machine power
cord
to
outlet.
To avoid electric shock,
use indoors only.
G ROU
N DING
IN
STR U
N S
To
protect the operator from electric
shock, this machine must be grounded
while in use. The vacuum is equipped
with an approved three-conductor power
cord and three-prong grounding type plug
to fit the proper grounding type recep-
tacle. The vacuum power cord has a plug
as shown in Fig. A. I f a receptacle con-
nected to the electricai ground as shown
in Fig. A is not available use an adapter
as shown in Fig. C. The adapter. must be
connected to an electrical
in
the
electrical outlet, using
shown in Fig.
B.
GROUNDING
PIN
netal screw
OUTLET
BOX
TAB FOR
GROUNDING SCREW
METAL
SCREW
I f
an extension cord is
used it must be an approved 3-wire cord
with a minimum wire size of
AWG
and a maximum length of 50 ft.
EQUIPMENT SETUP
NOTE:
Attach strain
retainer
to
power cord.
Make loop i n
power cord ap-
proximately
18"
from main hous-
ing.
2. Slide cord loop
through slot i n
retainer and over
retainer arm. Pull
slack cord back
through slot to
secure.
4
FILTER BAG
Install filter bag opening around the lip
of
opening on hopper cover. Secure bag by
bag strap tight.
NOTE
Optional plastic disposable bags
are available and can be installed in the
debris collector bin as shown in Photo
3.
HANDLE
The folding handle has two locked posi-
tions; operating and folded for storage.
To move handle from either locked posi-
tion pull out on both locking knobs and
rotate
turn. Move handle
to
position
needed and return knobs
to
the locked
position.
BRUSH HEIGHT ADJUSTMENT
WARNING:
Do
not leave brush running
unattended when machine is in cleaning
mode. Damage to carpet could occur.
To adjust the brush height, press down
on knob and move lever to the correct
setting for the carpet being vacuumed.
The brush setting is correct when the
bristles
sweep
the surface of the carpet.
WRONG
CORRECT
Summary of Contents for MX22
