1.
Ensure the appliance is switched “OFF”.
2. Carefully pour oil into the oil tank.
3. Ensure to fill the oil tank within the maximum and minimum markings located inside the oil tank.
Using the Appliance:
Before proceeding, you should have already filled the oil tank to the appropriate level and have placed the fryer
in a suitable operating position.
1. Connect the power cord to the wall outlet and flick the switch on. The red power indicator light will lid up.
2. Set the temperature knob to the desired temperature. The green power indicator light will now lid up.
3. Wait a moment for the oil to heat up to the desired temperature. It will take approximately 8-12mins for
the oil to heat up. This heating time is an indicative guideline only as it will depend on the type of oil and
quantity used.
NOTE:
•
The green indicator light will turn OFF when the selected temperature is reached.
•
During the frying cycle, the green indicator light will turn ON and OFF. This is normal as the appliance is
equipped with a temperature regulator.
4. Ensure the handle is hooked and clicked into position in the frying basket.
5. Place the food you wish to fry into the basket (e.g. potato fries) and slowly immerse the frying basket into
the heated oil.
6. During operation, the lid should not be used to cover over the appliance.
7. Supervision is required during the operation of the appliance.
8. Once food is cooked to your liking, lift up the frying basket and hook it over the edge of the appliance.
Allow the fried food to cool for a few minutes before serving.
9. Ensure to allow the appliance and the oil to completely cool down before starting the cleaning process.
NOTE:
Never exceed the maximum fill level.
NOTE:
Please note that your deep fryer is fitted with a safety interlock switch and will not operate unless
properly assembled.
Safety trip switch feature:
Should you accidentally switch
“
ON
”
your fryer without oil, or with insufficient oil; the fryer is equipped with
a safety trip switch feature which will automatically cut-out power in order to stop the appliance from
overheating. If this should happen:
1.
Firstly, disconnect the fryer from the wall outlet.
2.
Wait until the heating element cools down for approximately 30mins.
3.
Use a pin or a small screwdriver to push downward into the reset point. This will reset the fryer.
4.
The appliance will be ready for use again.