MAXIDRY MAXI200, Installation Manual, Page: 14 / 78

10 113261 - 1
SECTION III
INSTALLATION PROCEDURES
Installation in a proper location should be performed by competent technicians in accordance with local and state
codes. In the absence of these codes, the installation
must conform
to applicable American National Standards:
National Fuel Gas Code ANSI.Z223.1-LATEST EDITION and/or National Electrical Code ANSI/NFPA NO. 70-
LATEST EDITION, or in Canada, the Canadian Electrical Codes Parts 1 & 2 CSA C22.1-1990 or LATEST EDITION.
A. REASSEMBLY OF DRYER
IMPORTANT: Always keep the tumbler section of the dryer in an upright position when moving it.
The dryer may be shipped one of two ways; as a complete unit fully assembled and ready for hookup or with the
tumbler section separated from the base. If the dryer is shipped in two (2) pieces, the tumbler section will have to be
lifted onto the base. Use cables through the eyebolts on top of the tumbler section, or use a forklift for the lifting
process.
The tilting dryer is made in many loading and unloading options. Please refer to the reassembly instructions on the
following pages for your particular style of dryer.
If a steam dryer is shipped in two (2) pieces, the steam coil may have been removed from the top of the tumbler section
and shipped with the base. If this is the case, lift the steam coil onto the top of the tumbler section with the steam pipe
connections facing towards the right side of the dryer and bolt the coil to the top of the dryer with the 1/4” hardware
supplied. There are three (3) panels that cover the front, right side, and rear of the steam coil. Fasten these in position
also. Reconnect the steam and condensate pipe unions to the coil. These pipes run down to the flex hoses in the base.