MAXDATA PLATINUM 200 I, User Manual

Page: 13 / 37

PB 1 MAXDATA PLATINUM 00 I M9 Hardware Installations and Upgrades
3 Hardware Installations and Upgrades
Before You Begin
Before working with your server product, pay close attention to the “Safety Information” at the
beginning of this manual.
System references in relation to the chassis refer to a pedestal-mounted server when viewed from
the front.
Tools and Supplies Needed
•
Phillips (cross head) screwdriver (#1 bit and # bit)
•
Needle nosed pliers
•
Antistatic wrist strap and conductive foam pad (recommended)
Removing and Installing the Bezel Assembly
To remove the bezel assembly, follow these instructions:
1. Unlock the two plastic tabs on top of the bezel assembly by pressing lightly (see Figure 6, point A).
. Rotate the bezel assembly no more than 40 degrees forward and pull it diagonally upwards.
To install the bezel assembly, follow these instructions:
1. Place the bezel assembly with bezel hooks on the metal ridge on the lower front side of the
chassis. During installation, the bezel assembly is at an opening angle of approx. 0 degrees to
the top of the chassis.
. Rotate the bezel assembly towards the chassis and push against it so that the hooks snap into
place on top.
Figure 6. Bezel assembly
A