6
MAXDATA PLATINUM Server 90004R
Caution
For proper cooling and airflow, unless hot swapping PCI cards or fans, always reinstall the chassis
covers before turning on the system. Operating the system without the covers in place can
damage system parts. To install the covers:
1.
Check first to make sure you have not left loose tools or parts inside the system.
2.
Check that cables, add-in boards, and other components are properly installed.
3.
To replace the top back cover, slide the two bearing cages on the back top cover all the way
to the end of the slides.
4.
Place the top cover on the cover slides and push the cover into place.
5.
To replace the top front cover, attach the back edge of the front top cover to the chassis,
lower the front edge of the cover onto the chassis, then push the cover into place.
6.
Tighten the two captive screws on either side of the cover.
7.
Connect all external cables and the AC power cord(s) to the system.
Warning
A microprocessor and heat sink might be hot if the system has been running. Also, there might
be sharp pins and edges on some board and chassis parts. Contact should be made with care.
Consider wearing protective gloves.
Warning
Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent
type recommended by the equipment manufacturer. Discard used batteries according to manufac-
turer’s instructions.
The system is designed to operate in a typical office environment. Choose a site that is:
•
Clean and free of airborne particles (other than normal room dust).
•
Well-ventilated and away from sources of heat including direct sunlight.
•
Away from sources of vibration or physical shock.
•
Isolated from strong electromagnetic fields produced by electrical devices.
•
Protected when in regions that are susceptible to electrical storms. We recommend you
plug your system into a surge suppresser and disconnect telecommunication lines to your
modem during an electrical storm.
•
Provided with a properly grounded wall outlet.
•
Provided with sufficient space to access the power supply cords, because they serve as the
product’s main power disconnect.
Warning
Servers can be too heavy for a single person to lift or move safely. Depending on the server, use
two people or a mechanical assist to lift or move the server.