ENGLISH
14
2. Installation
2.1 Removing the Belt Clip
a. Pull the Belt Clip latch forward
(away from the WT350)
b. While pulling the Belt Clip
latch, push up the Belt Clip as
shown in Figure1.
2.2 Installing the Belt Clip
a. Slide the Belt Clip into the
slot as shown in Figure2.
A “click” indicates the Belt
Clip is locked into position.
2.3 Installing the Battery pack
Caution: Observe the proper battery polarity orientation when installing batteries. Incorrect
positioning can damage both the batteries and the unit.
a. Slide down the Battery Compartment Cover.
b. Install the rechargeable battery pack by following the orientation as shown in Figure 3 (the
arrow is showing and pointing upward.)
c. Replace the Battery Compartment Cover. See Figure 4.
d.
Important
Read these Safety Warnings before you charge the batteries.
When placing the WT350 in the charger,
use only the power supplies listed in the user
instructions supplied with the WT350.
Don’t try to recharge non-rechargeable batteries
.
Make sure the battery compartment cover is securely locked in place
when you are
charging the batteries.
Dispose of used batteries safely and in a way that will not harm the environment-
never
try to burn them or put them anywhere, they could get burnt or punctured.
Don’t leave dead batteries in your
WT350 units.
They might leak if you do.
Belt Clip latch
Figure 1
Figure 2
Figure 3
Figure 4
