14
14.5. Lap time data review
Enter the elevation set up and data review menu:
From any screen, press the left button for 2 seconds.
– On Wintech USB Alti and Wintech USB Ultimate, briefly press the left button (BPL) 3 times to switch to the lap time data review section: “Cr” appears on the computer screen.
– On Wintech USB HR, briefly press the left button (BPL) once to switch to the lap time data review section: “Cr” appears on the computer screen.
– On Wintech USB “Cr” appears on the computer screen.
Briefly press the right button (BPR) to enter the lap time data review section.
The review of the first lap time automatically starts in the following order:
– Elapsed time in the first lap time
– Distance ridden during the lap time
– Average speed during the lap time
– Average vertical speed during the lap time (Wintech USB Alti and Wintech USB Ultimate only)
– Average slope in % during the lap time (Wintech USB Alti and Wintech USB Ultimate only)
Each piece of information is displayed for 3 seconds.
If no lap time has been recorded during the trip, it is not possible to enter the lap time data review section
when briefly pressing the right button on the “Info” screen.
At any time of the sequence, briefly press the left button (BPL) to switch to the next lap time.
These data will cycle through until you press and hold the left button for 2 seconds. Then, the computer switches back to the last active screen.
If no button is pressed for 2 minutes, the computer automatically switches back to the last active screen.
14.5
2 sec.
Alti
Ultimate
USB
HR
3 click
1 click
1 click
after
3 sec
auto
1 click
1 click
1 click
1 click
1 click
next CR
next CR
next CR
next CR
next CR
after
3 sec
auto
after
3 sec
auto
after
3 sec
auto
after
3 sec
auto
any
screen
2 sec
2 sec
2 sec
2 sec
2 sec
EXIT
EXIT
EXIT
EXIT
EXIT
