2.03
TI013G0008
WARNING!!!
An adequate cleaning of both the machine
and the place where it is installed is
highly recommended.
For cleaning DO NOT USE
fl ammable fl
uids or products
not complying with current regulations.
In case of questions about the
compressor operation or of any of its
components, it is recommended to
contact the after sales service of Mattei
Compressors Inc
The following should be also considered:
The machine is equipped with an
Automatic start system that can allow
the machine to start without warning. It
is necessary to disconnect and lock out
the main power supply before performing
any work on the machine.
The key to open/close the cabin doors
should be entrusted with the specialized
staff.
The maintenance operations should
always be carried out when the
compressor is off.
Before carrying out any activity on the
compressor group, read the gauge to
ensure that no pressure is left inside.
Use only tools suitable for the type of
work.
Never use solvents and flammable
products to clean the machine or
individual parts.
Never carry out welding or other operation
that might require considerable heat
near the machine, speci
fi
cally near the
electrical equipment and the oil circuit.
Never make modi
fi
cations or carry our
welding on containers under pressure.
Never leave tools, cloths and other
loose items on either the motor or the
compressor.
The lubricating oil, especially if old, can
damage some people’s skin. Protect
your hands with gloves or with speci
fi
c
protective products for the skin.
Never wear clothing contaminated with
lubricating oil.
Avoid contaminating the ground with
lubricating oil.
To prevent pollution, store the old
lubricating oil in suitable containers and
in a safe place. To discard, observe the
recommendations set out by internal
regulations and by current laws.
In case of oil additions, use the same
type as the one already contained in the
machine.
Mixing oils is harmful to the life span of
both the oil and the compressor.
After any maintenance, start the machine
and check that all the devices for control,
stop or alarm work correctly. Verify also
that temperature and pressure values
are those foreseen.
Make the checks and the revisions as
foreseen by this manual, using only
original spare parts.
Not making these checks or using non-
original parts may cause problems that
jeopardize the correct operation of the
machine and cause the forfeiture of the
manufacturer’s warranty.
Responsibility
Ing. Enea MATTEI S.p.A. disclaims all
responsibility for injuries to people, or
damages to things and animals, if caused
by:
non-observance of the said precautions;
improper use of the compressed air or
the machine in general;
non-observance of ordinary safety rules
or domestic rules in the work place;
non-observance of instructions during
handling and transportation of the
machine;
incorrect installation of the machine;
defects due to the power supply line;
absence of regular maintenance;
unauthorized changes or intervention;
use of non-original spare parts or not
General information - Safety
