Matsusada EP Series, Instruction Manual

Page: 8 / 20

2
1-4 Points to be careful about in handling
・ For your safety connect the ground terminal of the chassis to EARTH securely
・ Use thicker (5SQ or thicker) and short wire for chassis grounding or load grounding, and
ground at one point of the ground.
・ Connect the shield wire of the output cable to the chassis side of the load.
(It will protect power supply or prohibit electrical shock from discharge at load)
・ DON’T TOUCH the load immediately after turning the output OFF. Before touching the
load, make sure that the Power ON/OFF switch of the unit is turned off and output
voltage is zero with power supply’s voltage monitor or another HV voltmeter.
How to GROUND
１－５ Troubleshooting
・In case there is no output voltage
１．Check if the proper input voltage is supplied to the power supply.
・ Power supply input voltage, 100－240V AC +/-10%, 50/60Hz single phase
Output cable
Ground terminal
Ground
EP
Load frame
load
1 Introduction