Matsui MS452S, Instruction Manual, Page: 5 / 21

450mm
2
Remove all packaging before positioning the
machine.
See the following diagram. Ensure there is a
clearance each side of the m achine to allow
slight side ways movement for servicing
Work top of your dishwasher is removable
if required. Height without the w orktop is
820 mm. This is applicable to MS452S,
MS452W , and MS452WE only.
By removing the machine's worktop, you can
install it under a close fitting sink unit or a
pre-existing top if the dimensions of the
recess correspond to those shown in the
picture.
To remove the worktop, please remove two
screws as shown at the rear of the worktop
on either side, lift up the rear section, and
push forward to release off the lug at the
front section of the appliance and lift up.
Remove the polystyrene block and if you
wish save for future re-use.
Position the machine next to a water tap and
a drain.
When inserting the maching, ensure that the
water inlet and drain hoses are not kinked or
squashed.
Care must be taken to ensure that the
appliance does not stand on the electrical
supply cable.
Good levelling is essential for correct closure
and sealing of the door.
When the appliance is correctly levelled,the
door will not catch on the inner liner on either
side of the cabinet.
If the door does not close correctly, loosen
or tighten the adjustable feet, until the
machine is perfectly level.
＂
For all the built-in models and some free standing models
(when you take off the top board and put the unit into the cabinet),
this condensation strip must be fitted to the underside of the worktop
above your dishwasher to protect it against any moisture. Its purpose
is to deflect steam rising from your appliance to protect your worktop's
underside.
•
•
•
The strip is located inside your dishwasher.
Ensure the surface is clean prior to sticking to
underside of the worktop.
Separate the backing paper from the strip.
Stick to the underside of the worktop.
•
Note: Failure to attach strip could result in damage to the underside of your
work surface!