Matsui MS452S, Instruction Manual, Page: 17 / 21

14
Never use a spray cleaner to clean the door panel as it m ay damage the door lock and electrical components.
Abrasive agent or some paper towel should not be used because of the risk of scratching or leaving spots on the
stainless steel surface.
To clean the edge around the door, you should use only a soft warm, damp cloth. To avoid
penetration of water into the door lock and electrical components, do not use a spray cleaner
of any kind.
Also, never use abrasive cleaners or scouring pads on the outer surfaces because they will
scratch the finishing. Some paper towels may also scratch or leave marks on the surface.
After every wash, turn off the water supply to the
appliance and leave the door slightly open so that
moisture and odours are not trapped inside.
Before cleaning or performing maintenance, always
remove the plug from the socket.
To clean the exterior and rubber parts of the dishwasher,
do not use solvents or abrasive cleaning products.
Only use a cloth with warm soapy water.
To remove spots or stains from the surface of the
interior, use a cloth dampened with water with a little
white vinegar, or a cleaning product m ade specifically
for dishwashers.
It is recommended that you run a wash cycle with the
dishwasher empty and then remove the plug from the
socket, turn off the water supply and leave the door
of the appliance slightly open. This will help the door
seals to last longer and prevent odours from forming
within the appliance.
If the appliance must be moved, try to keep it in the vertical
position.If absolutely necessary, it can be positioned on
its back.
One of the factors that cause odors to form in the
dishwasher is food that remains trapped in the seals.
Periodic cleaning w ith a damp sponge will prevent this
from occurring.
Please see the rating lable to know the rating voltage and connect the dishwasher to the appropriate power supply. Use required
fuse 13 amp. Fused electrical supply is required-copper wire only. Time delay fuse or circuit breaker recom mended and provide
separate circuit serving only this appliance. Outlet should be placed in adjacent cabinet.
Ensure the voltage and frequency of the power being used correspond to those on
the rating plate. Only insert the plug into an electrical socket which is earthed properly. If the
electrical socket to which the appliance must be connected is not appropriate for the
,
replace the socket, rather than using a adaptors or the like as they could cause overheating
and burns.
plug