INSTALLATION
23
GB
Moving and Installing
Removing the Anchor Bolts
Four anchor bolts keep the interior of the washing machine in place while it’s being moved.
They need to be removed before installation. Use a spanner (not supplied) and follow the
instructions detailed below.
Don’t run the washing machine without removing the bolts, as this can cause
excessive vibrations.
Moving the Washing Machine from One Location to Another
Make sure to fix the anchor bolts prior to moving the washing machine.
Before you move the washing machine
•
Shut off the tap and run the washing machine to drain the water. Drain any remaining
water from the pump hose.
•
Depressurise the water supply hose and remove it.
•
Disconnect the mains cable.
•
Attach the anchor bolts.
To remove the anchor bolts:
1. Use a spanner to loosen the bolts. They are located at the rear side of the washing machine.
2. Pull the bolts out horizontally. Make sure the entire bolt is removed.
3. Remove the 4 plastic bolt guides if not removed with the bolt.
4. Cover the holes with the cover caps
1
2
3
You’ll need the anchor bolts again if you move the washing machine, so make sure
you keep them in a safe place.
M510WM13E_IB_7L_RC_Final_131125.indb 23
25/11/2013 6:19 PM
Summary of Contents for M510WM13E
Page 2: ......
Page 45: ...45 NO Produktoversikt Enheten Vaskemiddelrom Servicepanel Kontrollpanel Avløpsslangen Vindu ...
Page 154: ......
