INST
ALLA
TION
GUIDE
GB-5
SECTION 2: INSTALLATION
Please pay attention to the following issues before using your washing machine.
REMOVAL.OF.TRANSPORTATION.SCREWS
• Transportation screws, which are located at the back rear of the machine, must be
removed before operating the machine.
• Loosen the screws by turning them anticlockwise with a suitable spanner. (DIAGRAM-1)
• Pull out the screws and rubber washers which may located at the rear side of the
machine. (DIAGRAM-2)
• Cover the holes where the transport screws have been removed with the plastic transport
caps found in the accessories bag. (DIAGRAM-3)
• Keep the transport screws in a safe place. The transportation screws that have been
removed from the machine must be re-used in any future transporting of the machine.
Diagram-1
Diagram-2
Diagram-3
FEET.ADJUSTMENT
• Do not install your machine on rugs or similar surfaces.
• For your machine to work silently and without any vibrations, it should be placed on a flat,
non-slippery and solid ground.
• Adjust the balance of your machine by: First loosening the plastic adjustment nut away
from the cabinet base. (A)
• Adjust the height by rotating the feet upwards or downwards. (B)
• After the machine is level, tighten the plastic adjustment nut again by rotating it upwards.
(C)
• Never attempt to balance the machine by placing cartons, wooden blocks or similar
materials under the feet.
A
B
C
M100WM10E_20100209_without PN.indd 5
