Password Settings
35
USB Controller
Use this item to enable or disable the onboard
USB ports.
USB Keyboard
Support
Use this item to enable or disable support for a
USB keyboard.
Password Settings
If you highlight this item and press
Enter
, a dialog box appears
which lets you enter a password. You can enter no more than six
letters or numbers. Press
Enter
after you have typed in the
password. A second dialog box asks you to retype the password for
confirmation. Press
Enter
after you have retyped it correctly. The
password is required at boot time, or when the user enters the setup
utility.
Change or Remove the Password
Highlight this item and type in the current password. At the next
dialog box, type in the new password, or just press Enter to disable
password protection.
IDE HDD Auto Detection
This item automatically detects and installs any hard disk drives
installed on the primary and secondary IDE channel. Most modern
drives can be detected. If you are using a very old drive that can’t
be detected, you can install it manually.
Setup will check for two devices on the primary IDE channel and
then two devices on the secondary IDE channel. At each device,
the system will flash an N in the dialog box. Press
Enter
to skip
the device and proceed to the next device. Press
Y
, then
Enter
to
tell the system to auto-detect the device.
Save and Exit Setup
Highlight this item and press
Enter
to exit the Setup utility without
saving any changes that you have made.
save the changes that you have made in the setup utility and exit
the setup program. When the Save and Exit dialog box appears,
