28
that you match the pin-1 side of the cable connector
with the pin-1 side of the device connector. Each
connector has the pin-1 side clearly marked. The
pin-1 side of each ribbon cable is always marked
with a colored stripe on the cable.
3. Plug one of the connectors on the FDD cable into the
FDD connector (B).
4. Plug a power cable from the case power supply into
the power connector on the FDD (C).
When you first start up your system, go immediately to the
Setup Utility and use the Standard page to configure the flop-
py diskette drives that you have installed. See Chapter 3 for
more information.
Installing Add-On Cards
This mainboard has six 32-bit PCI (Peripheral Components
Interconnect) expansion slots, one 4xAGP slot, and one
Communications and Networking Riser (CNR) slot.
PCI Slots
PCI slots are used to install expansion
cards that have the 32-bit PCI interface.
4xAGP Slot
The 4xAGP slot is used to install a graph-
ics adapter that supports the 4xAGP
specification and has a 4xAGP edge con-
nector.
CNR Slot
This slot is used to insert CNR cards in-
cluding LAN, Modem, and Audio functions.
