58
Modem Use IRQ
Default: 3
If you want an incoming call on a modem to automatically resume the system
from a power-saving mode, use this item to specify the interrupt request line
(IRQ) that is used by the modem. You might have to connect the fax/modem to a
mainboard Wake On Modem connector for this feature to work.
Suspend Mode
Default: Disabled
If you have selected User Define for the
Power Management
item, you can set
this item to a timeouts from 1 Min to 1 Hour. The system will go into the power-
saving suspend mode if the timeout passes without any system activity.
HDD Power Down
Default: Disabled
If you have selected User Define for the Power Management item, you can set
this item to a selection of timeouts from 1 to 15 minutes. The hard disk drive will
power down if the selected timeout passes without any activity on the hard disk.
Soft-Off by PWR-BTTN
Default: Instant-Off
Under ACPI (Advanced Configuration and Power management Interface) you
can create a software power down. In a software power down, the system can be
resumed by Wake Up Alarms. This item lets you install a software power down
that is controlled by the normal power button on your system. If the item is set to
Instant-Off, then the power button causes a software power down. If the item is
set to Delay 4 Sec. Then you have to hold the power button down for four
seconds to cause a software power down.
Wake Up by PCI Card
Default: Disabled
If you enable this item, it allows activity on an add-in card in one of the PCI slots
to resume the system from a power-saving mode.
Power On by Ring
Default: Disabled
If this item is enabled, it allows the system to resume from a software
powerdown or a power-saving mode whenever there is an incoming call to an
installed fax/modem. You might have to connect the fax/modem to a mainboard
Wake On Modem connector for this feature to work.
Wake Up On LAN
Default: Enabled
If this item is enabled, it allows the system to resume from a software
powerdown or a power-saving mode whenever there is an incoming traffic to a
network (LAN) adapter. You might have to connect the LAN card to a mainboard
Wake On LAN connector for this feature to work.
Resume by Alarm
Default: Disabled
If this item is Enabled, it allows you to set a date and time alarm that will
automatically resume the system from a software power down. When you enable
this feature, new setup items appear to let you set the alarm. Date (of Month)
Alarm lets you select a day from 1 to 31. Time Alarm lets you select a time for
the alarm in hours, minutes, and seconds.