BIOS Setup
37
Hard Disk Power
Down
This option specifies the power
conserving state that the hard disk drive
enters after the specified period of hard
drive inactivity has expired.
Hard Disk/Standby
Time out(Minute)
These options specified the length of hard
disk/system inactivity while in Full power
on state. When the length of time expires,
the computer enters Standby power
state.
Throttle Clock Ratio
Set this option to specify the ratio of the
system clock while in standby state.
Modem Use IRQ
Set this option to specify IO IRQ number
for modem device.
Serial Port 1;
Serial Port 2;
Parallel Port;
Primary master IDE;
Primary slave IDE;
Secondary master IDE;
Secondary slave IDE;
System Thermal
When set to
Yes
, these options will enable
event monitoring on the specified hard-
ware interrupt request line. In other word,
BIOS can detect activities on the specified
IRQ line. The system will go into power
saving state when there is no activities
detected within a specified time frame.
When occurs, the system turn to full power.
Thermal Slow Clock
Ratio
Set this option to specify the ratio of
system clock when CPU over the
Critical Termerature.
CPU Critical
Temperature
Set this option to specify critical
temperature for CPU.
Power Button Function
Set this option to specify the operation
of Soft-Off by the Power Button.
Restore on Ac/Power
Loss
Set this option to specify system power
state after sudden AC power loss. When
power restores system return to the state.
