Important Note:
Unauthorised modifications to the portable power source, not expressly
approved by the party responsible for radio frequency emission levels from
the portable power source, may cause an increased amount of radio frequency
energy to be emitted. Such a modification could void the customer’s authority
to use the portable power source.
FIRST TIME CHARGE PROCEDURES
When first purchased, the portable power source should be charged for a
minimum of 30 hours, unless all the power level lights and he charged light
comes on when the test button is pressed.
The power source can only be charged at 12V. Turn switch to 12V System and
Recharge then recharge power source.
Figure 1. Test button, Charging and Charge Volt meter.
RECHARGING THE PORTABLE POWER SOURCE WITH 240V
CHARGER
1. With the Switching Power Charger DC Extension Cord
a. Plug one end of the power extension courd into the portable
power source DC receptacle and connect to the harness device of the
Switching Power charger.
b. Connect the charger to the AC outlet (the orange standby/charging
light will turn on)
c. Allow the portable power source to charge until the charged light
illuminates on the Switching Power Charger.
d. Once the charged light comes on, device can be disconnected from
the Switching Power Charger.
Note: You can press the TEST button to check power level.
