background image

8

FAULT FINDING

WARRANTY POLICY

Products developed and sold by Tridon Australia Pty Ltd come with a guarantee for the reasonable 

life of the product, for the purpose it is commonly used.  This is in addition to the rights of the 

consumer under the Australian Consumer Law. To be considered for warranty please take the 

product with proof of purchase to the store where you purchased the product or contact  

Tridon Australia.
The warranty is given by Tridon Australia, 21 Derby St, Silverwater, NSW 2128  
Tel: 1300 362 263  Email: [email protected]
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law.  

You are entitled to a replacement or refund for a major failure and for compensation for any other 

reasonably foreseeable loss or damage incurred if the product fails when used for the purpose for 

which it was intended.  You are also entitled to have the goods repaired or replaced if the goods 

fail to be of acceptable quality and the failure does not amount to a major failure.
Tridon Australia will bear costs associated with claiming legitimate warranties.  Proof of expenses 

incurred must be submitted to Tridon Australia Pty Ltd.

Charger won’t indicate 

charging

   Charger not connected to battery
   Check terminal connection
   Battery is not 12 V

Battery won’t charge

   Verify that all wiring meets specifications
   Check condition of batteries
   Check performance of alternator

Battery won’t fully 

charge or hold charge 

   Battery that is over 3 years old; severely discharged (or previously 

been severely discharged); not regularly recharged;  

over-heated: low in electrolyte; undercharged; overcharged or 

sulphated may not accept or hold a charge.  

A good automotive store or battery outlet often offers a free or low 

cost in-store service to check condition of battery. Your battery may 

require replacement.

DCDS20A-0000-12-000-001 包装说明书-英文中性版

Davy

2018.12.6

A

Z075-3634.001

09

材质

:

157g

双铜板哑膜+骑马钉

表面要求:.

哑膜

80

20

-

Summary of Contents for MA21DCS









Reviews: