19
Using the Matrox MicroQuad Remote Control Panel
3
Under
Full Screen View
or
Quadrant View
, click
Input 1
,
Input 2
,
Input 3
, or
Input 4
to display an input source in full screen view, or select
an input source in quadrant view on your HDMI output display device. For
information on full screen view and quadrant view, see
“HDMI output
display”
on page
12
.
Alternatively, you can select an input source in full screen or quadrant view
using keyboard shortcuts (see
“Using the Matrox MicroQuad keyboard
shortcuts”
on page
20
) or the Matrox MicroQuad buttons (see
“Using the
Matrox MicroQuad buttons”
on page
14
).
Remarks
$
If the resolution and frame rate on all SDI input sources do not match,
only SDI input channel 1 (SDI 1) will be displayed while the other
channels will appear black.
$
Switching between quadrant view and full screen view, or switching from
one input source to another is done without signal interruption.
4
Under
HDMI Labels
, you can customize the labels that appear on the HDMI
display device. Enter or select the HDMI label that you would like for each
input in the
Label input 1
,
Label input 2
,
Label input 3
, and/or
Label
input 4
boxes. The Matrox MicroQuad Remote Control Panel will retain the
last five HDMI labels that were entered so that you can re-use your most
common labels.
Remarks
$
The HDMI labels are limited to ten characters.
$
If you disconnect the USB cable from the Matrox MicroQuad unit, the
unit will display the current HDMI labels.
5
Under
VU Meter and Output Audio Channel Selection
, select the audio
input channels that you would like to monitor on the VU meters and output
to the HDMI display device. If you select
1-2
,
3-4
,
5-6
, or
7-8
, the selected
audio input pair will be displayed on the VU meters and output to the HDMI
display device. If you select
1 to 8
, audio input channels 1 to 8 will be
output to the HDMI display device and only audio input pair 1-2 will be
displayed on the VU meters. For more information about monitoring audio
levels, see
“Monitoring audio levels”
on page
13
.
¦
Note
If you do not indicate which audio pairs to output, audio input
channels 1 to 8 will be output by default and audio input pair 1-2 will be
displayed on the VU meters.
