Board input and output connectors
51
The mating connector included with the board is a 30-pin male, 0.050 pitch right
angle connector. For customers planning to build their own cable, parts can be
purchased from:
This connector interfaces with a ribbon cable, 0.025 inch pitch (0.635 mm),
AWG #30 (solid wire).
BNC connector
The BNC connector provides a single composite input to the
Matrox Meteor-II /Standard board. Its pin assignments are as follows:
• 1: composite 1 or VID_IN1.
• 2 (SHELL): ground.
You can use a standard video cable (available from your local electronic store) to
interface with this connector.
VMChannel interface connector
The VMChannel interface allows Matrox Meteor-II /Standard to share data with
any Matrox imaging board that has a VMChannel interface capable of performing
the bus controller function. A VMChannel backplane (available with the
GEN-BUS/... interconnect kits) must be inserted across the VMChannel
interfaces of the boards.
20
VID_IN8
I
Analog Video Input #8 or Y4
22
VID_IN9
I
Analog Video Input #9 or Y5
23
OPTOTRIG-
I
Opto-Isolated trigger negative input
24
O
I
Opto-Isolated trigger positive input
26
VID_IN10
I
Analog Video Input #10 or C5
28
VID_IN11
I
Analog Video Input #11 or Y6
30
VID_IN12
I
Analog Video Input #12 or C6
1, 3, 5, 7, 9, 11, 13,
19, 21, 25, 27, 29
GND
Ground
Manufacturer:
Fujitsu
Connector: FCN-217J030-G/O
Pin
Signal
I/O
Description
2
1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
