17
6.7 ROPE REPlACEMENT
CHAPTER 6: PART REPlACEMENT GUIDE
fIGURE A
fIGURE b
1) Remove the right side middle shroud as outlined in Section 6.2.
2) Remove the console as outlined in Section 6.3.
3) Remove the handlebar from the rope as outlined in Section 6.4.
4) Remove the rubber center cover as outlined in Section 6.5.
5) Remove the plastic center cover as outlined in Section 6.6.
6) Remove the rubber ball from the end of the rope (figure A).
7) Allow the rope to coil around the rope axle.
8) loosen the screws attaching the rope to the rope axle (figure b).
9) Cut the rope and remove it.
10) Reverse Steps 1-9 to install a new rope. NOTE: When replacing the rope, first thread the rope through the guide hole of the rope axle and tie a knot,
then tighten the bracket screws.
11) Test the rower for function as outlined in Section 6.19.
