18
18
How to Install the Hob
1. Make the required hole in the worktop. Note that before doing this,
check the instructions supplied with any cooker hood to ensure that
you will have the required clearance. The cut-out (Fig. 10) shows a
61.5mm gap from the wall to the cut-out edge. The distance for
the hob, when fitted, to the back wall is 50mm.
2. Position the hob seal, as shown in the diagram below (Fig. 12),
ensuring that the ends meet without overlapping. Do not use silicone
type sealant.
3. Secure the hob to the worktop using the fixing brackets and screws
supplied, as shown in the following diagram (Fig. 13). Remove any
excess seal after tightening the brackets.
Installation Dimensions (mm)
MHG201
Overall width
680
Overall depth
500
Worktop cutout width
557
Worktop cutout depth
477
