Matrix Cosec Door, Quick Start Manual

Page: 24 / 32

Place the threaded screw M 3x6 as provided in the
package
in this slot and tighten the same to fix the Door Controller
unit to the mounting plate.
Step 9: Powering up the Door Controller
Once all the connections are checked, power up the Door
Controller which in turn will go through the booting process.
The LCD display will first display the Matrix logo followed by
the firmware version, RS485 address of the controller as set
on the dip switch and the MAC address of the door controller
for a few seconds. Make a note of this address as it will be
used in the COSEC application in the event of an Ethernet
network.
Power up all the DOOR Controllers once after they have
been defined and configured in the COSEC application as
described in the COSEC System manual. Also ensure that
the PANELS if any on the network are also powered up
prior to powering up the DOOR Controllers. This is to
ensure that the PANEL can start downloading the PANEL
DOOR firmware to all DOORs on the network which have
been configured as PANEL DOORs as this operation only
when the DOORs are in the reboot process.
Setting the IP address of the DIRECT DOOR:
The DIRECT DOORs come preconfigured with a default IP
address. The System Engineer would need to connect the
DIRECT DOORs one at a time on the network and configure
their IP address as explained in this section.
After powering up the DIRECT DOOR the user needs to