Matrix 210.100.100, Original Instructions Manual

Page: 63 / 271

Connecting the chip/dust extractor
63
KUNDENDIENST
service@matrix-direct.net
DE
+49 (0) 1806/841090
F
B
E C
D
16
1. Put the motor flange (E) on the motor shaft (F). Make sure it is correctly aligned in the
process.
2. Loosen the bottom saw blade cover and run the new saw blade (D) through the saw
blade cover from below. Take note of the direction of rotation of the saw blade in the
process. The correct direction of rotation is marked on the saw blade and the saw
blade cover.
3. Place the cover flange (C) and the washer (B) on the motor shaft.
4. Turn the saw blade screw
16
anticlockwise to screw it in.
Notice!
Observe the arrows indicating the direction of rotation on the saw blade. Always attach
the saw blade so that it is pointing in the same direction as the directional arrows on
the saw blade cover.
Connecting the chip/dust extractor
WARNING!
Injury to health:
Improper use of the saw could damage your health.
• Do not use this saw to cut through materials that could harm your health
such as asbestos.
• Dust from materials whose constituents include e.g. paint coats containing
lead, some types of wood, minerals and metal could be harmful to health.
Contact with them or inhalation could cause allergic reactions and/or
respiratory diseases. The dust from certain types of wood (e.g. oak or beech)
is considered carcinogenic, particularly in combination with wood treatment
agents or other additives.
GB