Matrix Vision mvBlueFOX, Technical Manual, Page: 57 / 255

50 CONTENTS
Pin Signal 'R' version Signal 'U' version
1 USBPOWER_IN Power out from USB
2 D+ not connected
3 GND GND
4 D- not connected
Manufacturer: Binder
Part number: 99-3390-282-04
Note
Differentiation between 'R' and 'U' version is obsolete. New mvBlueFOX versions have both connectors (cir-
cular connector and standard USB). The pin assignment corresponds to the description of 'R' version.
While mvBlueFOX is connected and powered via standard USB, it is possible to connect additional power via
circular connector (
only power; the data lines must be disconnected! ). Only in this case, the power switch
will change the power supply, if the current entry via standard USB is equal to or under the power supply of
"circular connector"
.
Attention
Do not connect both USB ports at the same time.
8.2.2 LED states
State LED
Camera is not connected or defect LED off
Camera is connected and active Green light on
8.2.3 Components
• FPGA for image processing
• pixel clock up to 40 MHz
• reliable image transfer
– using bulk-mode
– image data surrounded by headers
• several trigger modes
– auto, SW, external
• flash control output
– using opto-isolated outputs
• opto-isolated I/O
– 2 inputs, 2 outputs on D-Sub 9 connector
• bus powered
– no external power supply needed
MATRIX VISION GmbH