MSC-XD164S Product Manual
>
PanelCond 68,”P1”
>
PanelCond 68,””
>
The first example above queries the currently assigned panel/GPIO conditions, which shows that button number
1 and 2 have P0 and P1 conditions assigned respectively, which lights the button LEDs when the current matrix
routing matches preset 0 or preset 1 respectively, and GPIO pin 3 (GPIO pins start at 65) will output a logic 1 if
the matrix matches preset 0. The second command queries the panel condition for button 1. The third
command assigns the condition “P1” to GPIO pin 4 (ID 68). The fourth command clears the condition assigned
to GPIO pin 4.
3.10.26 PanelDis Command
Protocol Version: 2.4
Query or assign internal button interface panel disable setting. This setting is stored and recalled on power up.
Command
Description
PanelDis
Query internal panel disable setting.
PanelDis 0 | 1
Assign internal panel disable setting (0: enable, 1: disable)
Examples
>PanelDis
0
>PanelDis 1
>
The first command queries the current panel disable setting (0: enabled). The second command disables the
internal panel interface.
3.10.27 PanelExtEn Command
Carina series only - Protocol Version: 2.4
Query or assign external button interface panel enable setting (if applicable – not all router devices have an
external panel interface). This setting is stored and recalled on power up.
Command
Description
PanelExtEn
Query external panel interface enable setting.
PanelExtEn 0 | 1
Assign external panel interface enable setting (0: disable, 0: enable)
Examples
>PanelExtEn
0
>PanelExtEn 1
>
Page 40 of 60
© 2013-2016 Matrix Switch Corporation
