Matrix Elements GT1000fX, User Manual

Page: 6 / 24

5
6 7
9
8
5
1:A
For Bridged Output Use Socket Marked X - For Bridged Output Only !
DO NOT REMOVE COVERS
LETHAL VOLTAGES INSIDE.
THIS EQUIPMENT MUST BE
EARTHED. DO NOT USE IN
DAMP CONDITIONS.
AC Power Supply Requirement
110V 12A
230V 6A 50 to
60Hz
1/4” & XLR IN
1/4” & SPKN. OUT
+0
d
Bu/0.7V
+
_
DESIGNED BY ANDREW HUNT AND MANUFACTURED IN THE UK BY MATRIX
WWW.MATRIXGUITARAMPLIFICATION.COM
X
+
1U MODEL (GT800 & GT1000) & 2U MODEL (GT1000 & GT1600)
(5) Cooling Fan Outlets
Hot air exits here. Make sure all rear (and front) ventilation paths are
free from obstruction and air flows freely, otherwise the amplifier will
trip into thermal protect mode prematurely and in some extreme
circumstances damage may occur.
(6) Output Connectors
The Output sockets are Neutrik® Speakon / 1/4” combi connectors.
They accept both Neutrik® NL2FC & 1/4” jack plugs (NL4FC
accepted, however only terminal pair 1 carry signals). Avoid inferior
alternatives, as they may present numerous hazards due to less than
ideal construction.
When inserting speakon plugs turn clockwise until you hear it
click; This ensures correct connection has been made. To remove, pull
back the levered tab and turn anti-clockwise.
Ready-made, sensibly priced, quality interconnection leads
suitable for use with the amplifier should be easy to source. However,
with sufficient skill, it is possible to make/modify leads for the task.
• Only the first two pins (+1 and -1) are used in this amplifier.
•
When utilising the 1/4” output option the centre pin (Tip) is
connected to +1 & the outer sheath (Sleeve) is connected to
-1.
•
For STEREO/MONO operation, unmodified “off the shelf”
cables will usually work fine.
•
For BRIDGED MONO mode, Output is exclusively available
from OUTPUT X, do not use at any other time.
X
1:A
For A+B Bridged Output Use Socket Marked X
For Bridged Output Only !
DO NOT REMOVE COVERS
LETHAL VOLTAGES INSIDE.
THIS EQUIPMENT MUST BE
EARTHED.
DO NOT USE IN
DAMP CONDITIONS.
AC Power Supply Requirement
110V 12A
230V 6A 50 to
60Hz
+ _
NL2
1/4” NL2
1/4” NL2
1/4”
Both Input and Output Connectors
Accept 1/4” Jackplugs in Addition to XLR/NL2
+0
d
Bu/0.775V
DESIGNED BY ANDREW HUNT AND MANUFACTURED IN THE UK BY MATRIX
WWW.MATRIXGUITARAMPLIFICATION.COM
1:X
1/4” & SPKN. OUT
1/4” & XLR IN
+