Installation
Page 8
4
Installation
Danger!
Switch off the tractor and remove the ignition key before mounting or
dismounting the implements.
Note!
Enter the vehicle identification number of the spreader in section 7.3 of this
operating manual.
4.1
Tractor requirements
The following requirements must be met for safe and authorized use of the box spreader.
Make allowance for the axle loads of the tractor!
•
Make allowance for the tractor axle loads!
•
Three-point hitch category 1, 2 or 1N
•
Universal joint shaft connection: 1 3/8”, 6
-part, 540 rpm if the spreader is
mechanically driven.
•
Hydraulic power:
o
1 control circuit required if the spreader is hydraulically driven.
o
1 control circuit required if the dosing unit is hydraulically controlled.
o
Volume flow rate: at least 15 L/min; pressure 150 bar
•
Vehicle electrical system 12 V if the dosing unit is electrically controlled and for lights
and work light.
4.2
Mounting in the tractor’s rear three
-point linkage
Note!
The box spreader is a compact implement that can be mounted on
numerous different tractors.
This spreader can be mounted on tractors with the following read three-point hydraulic
system of the following categories:
•
Cat 1
•
Cat 1-N
•
Cat 2 (not possible with SPR-HM-80)
Mount the spreader in the tractor’s rear three
-point linkage. Make sure to use the correct
connecting points corresponding to the three-point linkage.
