10100125 - A
© Matan Digital Printers Ltd
Page 6 of 19
15. Attach the red gasket to the drain plug and tightly close the
drain hole with the plug, as shown below.
If the gasket is not in good condition, you should replace it.
16. Connect the two new metal fittings to the tank's threaded
fittings, using a #12 metric wrench, as shown below.
These fittings don’t need Loctite or any other sealing
material, as they have their own built-in plastic O-ring.
17. Relocate the MIT on the printer's chassis and attach it with
the four screws.
18. Repeat all the above steps for the other three tanks.
