Masterweld MW8002, Instruction Manual For Use And Maintenance

Page: 18 / 25

MW8002
Rev 00.00 Page 18 of
25
©| AES Industrial Supplies Ltd | 2019 all rights reserved Unauthorized reproduction of this manual is prohibited
.
Bad smell Activated carbons filter full Change
FUNCTIONING
Par Description
3 Risks and emergencies
Risks
Description hazards and specific protections
The manufacturer has, however, taken steps to reduce the dangers that can arise due to incorrect use of the
machine by installing on the machine itself of the protection devices.
Description hazards cannot be eliminated by the security measures adopted
The dangers cannot be eliminated by the security measures taken by the manufacturer are caused by incorrect
use of the machine or by a failure on the part of the user of the safety instructions in this manual (refer to the
above concerning the things do not do).
As already mentioned above we recommend the use of gloves and mask during cleaning and filter change, in
order to avoid the possible consequences to the operator.
Emergency situations
In case of fire:
-
Use powder comply with standards
-
Pay attention to the combustion gases (polyester filters and plastic electrical plant)
The materials and substances used in the construction of the equipment does not pose a risk of explosion.
IMPORTANT NOTE
THE EQUIPMENT SHOULD NOT BE USED IN EXPLOSIVE ATMOSPHERE
MAINTENANCE
Par Description
2 MW8002 - Cleaning and change of parts
For model MW8002 open the dust separating panel (1) from the entrance of fumes acting on the enclosure
(2), then after removing the grill (3) must be emptied of the parts that were deposited on the inside.
Then unscrew the locking knob (4) Cartridges (pre-filter (5) external microfilter (6) inside) and then take them
off outside taking care not to drop them. Pull out the fine filter and wash with a jet of air from inside to outside
the pre-filter and same goes also to the microfilter.
Then replace the cartridges one inside the other and reposition them in their seat blocking in the bottom panel
(4).
From the side air outlet remove the panel (7) acting on the side locks but not before having removed with a
tool safety screw.