6
1. Ensure that the power cord is disconnected from the power outlet (figure 1).
2. Undo the clasps (figure 2).
3. Lift the top section off the tank (figure 3).
4. Remove the contents from inside the tank (figure 4).
5. Turn the tank upside down and insert casters on to the two front feet and secure with the supplied
screws. Verify that they are mounted correctly. Do not over tighten (figure 5).
6. Insert the rear wheel support block and secure with the supplied screws. Verify that they are
mounted correctly. Do not overtighten (figure 6).
7. Insert the wheel shaft (B) into the rear support block (A). Put washer (C) and then the wheel (D) on
the shaft. Insert the ‘R’ lock pin into the hole on the end of the shaft to lock the wheel. Snap the
wheel cover (E) on to the wheel. Repeat the same at the other end of the shaft (figure 7a and 7b).
8. Insert the push main handle into the handle socket mounted on the tank body. Push down until the
lock pin clicks in place (figure 8).
9. For dry vacuum cleaning, install the supplied 3-layer cartridge filter (figure 9).
10. For wet vacuum cleaning, install the supplied foam filter (figure 10).
11. Replace the top section on the tank (figure 11).
12. Align the top section with the clasps, and snap into place by applying pressure until the clasps click
(figure 12).
13. Insert the large end of the hose into the front inlet of the tank, and turn to lock (figure 13).
14. Fit the required accessory on to the suction tube (figure 14).
General Assembly Instructions
