10
REPLACEMENT FILTERS
Replace filters regularly.
3-layer cartridge filter (054-0103-8) (part # 32)
Foam filter (054-0210-2) (part # 34)
MAINTENANCE
WARNING!
Always disconnect the plug from the wall power outlet before removing the tank cover.
NOTICE!
This
fi
lter is made of high quality paper designed to stop small particles of dust. The
fi
lter should
be used for dry pick-up. It is necessary to use a dry
fi
lter to pick up dust as a wet filter will clog quickly and
will be very difficult to clean. Handle the
fi
lter with care when removing it for cleaning or during installation.
Check the
fi
lter for tears or small holes as even a small hole can allow dust to pass through and out of the
cleaner. Do not use a
fi
lter with holes or tears, replace it immediately.
INSTALLATION AND CLEANING
1. Slide cartridge filter down over filter cage (figure 1 & 2).
2. Place retainer on top of cartridge filter against hole of basket (figure 3).
3. Hold lid assembly and turn retainer clockwise until tight. Ensure that there is no gap between filter and lid
assembly (figure 4).
4. To remove filter for cleaning again, hold lid assembly with one hand and turn retainer counter-clockwise
(figure 5).
5. Slide cartridge filter off filter cage (figure 6).
6. Clean filter by tapping it on inside of trash can (figure 7).
7. Clean filter by rinsing from the inside (figure 7).
8. When wet (to prevent mold and/or mildew build-up), the cartridge filter should be moved and allowed to
air dry for a 24-hour period before being re-installed back onto the filter cage.
3-Layer Cartridge Filter
