9
FIG 63
Each Time you remove the windows:
Completely pull the windows out of the “C” Channel
before pulling the windows down!
Do not “Pe
e
l” the windows out. See Fig 55.
There may be times when the “P” extrusion may come out of the “C” Channel ends due to
extreme downward pressure. This is normal. If this occurs, slide the “P” extrusion out of
the C channel and re install securing the window back into the “C” Channel.
NOTICE
When removing the quarter and rear windows from the Top deck be sure to slide them out
completely before pulling down. Disengage the side hook and loop before sliding the win-
dows out. DO NOT “Peel” the windows out! Failure to completely disengage the windows
from the “C” Channel will damage the Top and quarter window!
NOTICE
FIG 56
FIG 57
Step 17: Securing the Side and Rear Windows to the Vehicle
FIG 58
FIG 59
As shown in fig’s 56 & 57, roll the vertical plastic
strip into the door surround slot securing it to the
door surround. Next, starting at the driver’s side
front, attach the side belt rail into the vehicle body
by “rolling” the plastic into the slot (FIG’s 58 & 59).
Note:
You may have to pull the corners around to-
wards the front or back of the vehicle to center the
top on the vehicle.
If this is too difficult, release the
front windshield header latches. Once installed
the first time these windows will easily install.
Repeat this on the passenger side centering the
top over the rear bow.
Seal hook and loop around windows (Fig 60 & 61)
FIG 60
FIG 61
FIG 55